CNC machining center operation experience
6) When doing medium light, NC technicians should pay special attention to the place that is not opened when opening rough, to prevent the tool from crashing into this area.
7) Program cutting. In case the program is interrupted during processing and too much time is wasted from scratch, the group leader and programmer should be informed to modify the program and cut off the part that has been done.
8) Program exception. If the program appears abnormal, and uncertain, can be lifted to observe the process, and then decide the next action.
9) The speed and speed provided by the programmer in the processing process can be adjusted by the NC mechanic according to the situation. But special attention should be paid to the small copper open coarse speed can not be opened fast, in order to avoid vibration caused by the loosening of the workpiece.
Kevin
kevin@jntime.com
Tel/Whatsapp: +86 15863141078
Address: No. 3999 , Airport Road, Lingang Economic Development Zone, Jinan,Shandong,China
Zip:250107 Fax:0531-8873 5288 Sales Hotline:0531-8873 5188
After-Sales Hotline:136 0641 1517/150 2000 3877/133 0531 7322