Notes for correcting and aligning workpiece
4) All workpieces must be divided in the middle way, and the zero position on the edge of the work piece must be divided in the middle way and then moved to the edge, and the margin on both sides must be consistent. In case of special cases where unilateral number selection is necessary, it must be confirmed by the production team again before passing. After taking the number of one side, remember the radius of the rod in the compensation return.
5) The zero input of the workpiece center must be the same as the three-axis center of the workstation.
Kevin
kevin@jntime.com
Tel/Whatsapp: +86 15863141078
Address: No. 3999 , Airport Road, Lingang Economic Development Zone, Jinan,Shandong,China
Zip:250107 Fax:0531-8873 5288 Sales Hotline:0531-8873 5188
After-Sales Hotline:136 0641 1517/150 2000 3877/133 0531 7322