Precautions for clamping workpieces
6) Clean the workbench and the bottom of the workpiece before putting the workpiece on the machine. The machine table and workpiece surface shall be pushed off the rough edges and damaged positions with oilstone.
7) When coding, make sure that the coder will not be hurt by the knife. If necessary, communicate with the programmer. At the same time, if the bottom pad is square, the code must be aligned with the square position of the pad to achieve the purpose of force balance.
8) When clamping with vice, the machining depth of the tool must be understood to prevent the clamped position from being too long or too short.
9) The screws must be put into the T-shaped block, and not only part of the thread is allowed. If it is necessary to connect the screws, the upper and lower screws must each use half of the thread of the joint. The thread of the nut on the pressing plate must be completely used, and only a few threads are allowed.
10) When setting the Z depth, the position of the program single touch number and the data of the highest point of Z should be clearly seen. After inputting the data into the machine tool, it must be checked again.
Kevin
kevin@jntime.com
Tel/Whatsapp: +86 15863141078
Address: No. 3999 , Airport Road, Lingang Economic Development Zone, Jinan,Shandong,China
Zip:250107 Fax:0531-8873 5288 Sales Hotline:0531-8873 5188
After-Sales Hotline:136 0641 1517/150 2000 3877/133 0531 7322