Large and small taper head of workpiece.
Cause: the placement level of the machine tool is not adjusted well, one high and one low, resulting in unstable placement; When turning a long shaft, the contributing material is relatively hard and the cutting tool is deep, resulting in the phenomenon of tool yielding; The ejector pin of tailstock is not concentric with the main shaft.
Kevin
kevin@jntime.com
Address: No. 3999 , Airport Road, Lingang Economic Development Zone, Jinan,Shandong,China
Zip:250107 Fax:0531-8873 5288 Sales Hotline:0531-8873 5188
After-Sales Hotline:136 0641 1517/150 2000 3877/133 0531 7322