Tool jam during machining
4) After troubleshooting the initial fault, turn the cutter arm motor brake back to the original position, and then change the cutter once when the high-speed vertical machining center is in MDI state to see whether it is normal. If you want to learn UG programming and NC programming of the machining center, learn to add QQ group: 304214709 to receive learning materials and courses. If it is normal, please remember to check all the knives to be used for processing and carry out processing under the condition of ensuring safety.
Kevin
kevin@jntime.com
Address: No. 3999 , Airport Road, Lingang Economic Development Zone, Jinan,Shandong,China
Zip:250107 Fax:0531-8873 5288 Sales Hotline:0531-8873 5188
After-Sales Hotline:136 0641 1517/150 2000 3877/133 0531 7322