ForCNC angle line ,first confirm it’s electricor machinery problem, if workpiece punch single row hole, in the processing ofautomatically running, A/B location does not move, then observe whether the rawmaterials keep one line with V datum in the process of punching, if not, check ifpressure is expected to reach the designated position, whether there is one supportpoint in feeding path.
If workpiece is a double row holes , use calipers measure the position ofthe punching mould to check if the big and small alignment remain consistent.If ok, meanwhile, the depth and big/small alignment difference keep same, thereis also possible of pressure not reach right position. If different not keepsame, it means there is gaps during the mould moving ,please check the screwstable, check mould moving ,also need to check if bolt of screw and mouldconnection parts is loosen. Make sure screw moving smoothly, eliminate thegaps. If the depth don’t have rules, please consider electrical interference, groundto eliminate it .
Any problems of CNCangle line, just contact Jinan Supertime(kate@jntime.com)
Address: No. 3999 , Airport Road, Lingang Economic Development Zone, Jinan,Shandong,China
Zip:250107 Fax:0531-8873 5288 Sales Hotline:0531-8873 5188
After-Sales Hotline:136 0641 1517/150 2000 3877/133 0531 7322